Graco 308395D Manual do Utilizador

InstructionsHydraulic Fluid Controls308395DENRegulates hydraulic pressure and flow when used with Graco’s Dyna-Star™ and Power-Star™ hydraulic-powered

Parts 10 308395DPartsModel 236864 Hydraulic Fluid Control113a113b111105104108109106102112107113Includes items113a & 113b1031110110103Ref. Part Des

Parts308395D 11Model 236865 Hydraulic Fluid Control113b107102105106103112113109104113a108Includes items113a & 113b111111110110Ref. Part Descriptio

Technical Data 12 308395DTechnical DataDimensionsHydraulic Fluid Controls: Dyna-Star™US MetricMaximum fluid working pressure 1500 psi 10.5 MPa, 105 b

Notes308395D 13Notes

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves th

Warnings 2 308395DWarningsThe following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point

Warnings308395D 3EQUIPMENT MISUSE HAZARDMisuse can cause death or serious injury.• Do not operate the unit when fatigued or under the influence of dru

Installation 4 308395DInstallation GroundingPump: use ground wire and clamp (supplied). Loosen grounding lug locknut (W) and washer (V). Insert one en

Installation308395D 5Typical InstallationKey:A Hydraulic Control, 236864B Hydraulic Control, 236865C Hydraulic Return LineD Hydraulic Outlet, 3/4 npsm

Installation 6 308395DInstallation Notes• Blow out all hydraulic lines with air, flush thoroughly with solvent, and then blow out the air again before

Operation308395D 7OperationPressure Relief ProcedureFollow the Pressure Relief Procedure whenever you see this symbol.1. Close the supply line shutoff

Repair 8 308395DShutdown Always shut off the supply line shutoff valve (E) first, and then the return line shutoff valve (G). This is to prevent over

Troubleshooting308395D 9TroubleshootingProblem Cause SolutionNo pressure on gauge, or low pres-sure on gaugeHydraulic power supply malfunction or mis-